-
Q: |
Why can't I use WDS mode on Airmax2? |
A: |
Please upgrade the f/w to the latest one on our Web site, we had fixed some WDS issue in the latest f/w, and set the WDS Encryption type as WEP. |
-
Q: |
How many WDS connections can be supported by AirMax2? |
A: |
AirMax2 can support WDS connection up to 8. |
-
Q: |
How to Configure AirMax2 as Universal Repeater? |
-
Q: |
Does AirMax2 support super channel? |
A: |
AirMax2 works in 11 channels (USA) and 13 channels (ETSI), and not support super channel. |
-
Q: |
AirMax2 is configured as AP Router, and is connected by wireless IP camera. I would like to access the IP camera from internet via port 80. What should I do? |
A: |
AirMax2 remote management port is 80. If IP camera would like to be connected by port 80, please change Airmax2 remote management to another port, and configure IP camera as virtual server. Please refer to the user manual page 52 to change AirMax2 remote management port, and page 47 about virtual server setting. |
-
Q: |
Where can I purchase the optional metal Mounting Kit? |
A: |
The part number for the mounting kit is “WMK-AIRMAX”. Please ask your authorized AirLive distributor for availability. |
-
Q: |
My wireless network card could find the access point, but it could not connect to the access point successfully. |
A: |
The wireless network card might not have enough transmittion power to connect to the remote access point. Please use high power wireless network card. |
-
Q: |
I have adjusted the TX Power maximum. Why the wireless network card nearby could not connect to access point? |
A: |
Sometimes too much power can cause problem like near field effect(it's a law of physics). Please turn down the TX power. |
-
Q: |
If I could not enter AirMax2 web management, what could I do? |
-
Q: |
Why is my settings unchanged after pressing the “Apply” button? |
A: |
Please reboot your AirMax2 after all the settings are changed. |
-
Q: |
What can I do if I forget my password or the IP address of AirMax2. |
A: |
Please restore your settings to default by press the reset button for more than 5 seconds. You should be able to find your AirMax2 at 192.168.1.1 with default username “admin” and password “airlive”. |
-
Q: |
When AirMax2 switch to AP Router mode, why can't I connect to AirMax2 with Device LAN IP? |
A: |
"When you change to “AP Router” mode, the LAN port will become WAN port. The IP address is changed to “192.168.2.1”. Please Change your PC IP to 192.168.2.X, and open the web console with the IP address ""192.168.2.1." |
-
Q: |
How to connect to AirMax2 using bridge mode? |
-
Q: |
I need to install AirMax2/AirMax5 in the tower. How can I make the process easier? |
A: |
You should install the cable and close the AirMax first before bring the device to the tower. |
-
Q: |
Sometimes when I change settings and reboot. The AP can't be found at the same IP address? |
A: |
If you change settings remotely, it is possible that the reboot time takes longer than what the web UI shows. Please wait for 5 minutes and try to access the page again. |
|